User manual

Problem Possible cause Remedy
The display shows an error
code that is not in this ta-
ble.
There is an electrical fault. • Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The demo mode is activa-
ted.
1. Deactivate the oven.
2. Touch and hold until
the oven activates and
deactivates.
3. Touch and hold and
at the same time un-
til an acoustic signal
sounds and "Demo"
goes out.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
13. INSTALLATION
WARNING!
Refer to Safety chapters.
13.1 Building in
During installation in
combustible matter, NIN SEV
1000 and fire protection
guidelines and regulations of
the Association of Cantonal
Fire Insurance shall be strictly
adhered to.
1. Pull the appliance drawer out as far as
it goes and remove it.
2. Place the appliance in front of the
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
3. Push the appliance into the recess.
A = appliance, N = recess
ENGLISH
21