User manual

water and a cleaning agent. Do not clean
the accessories in the dishwasher.
Clean stubborn dirt with a special oven
cleaner. Do not apply oven cleaner on
the catalytic surfaces.
If you have nonstick accessories, do not
clean them using aggressive agents,
sharp-edged objects or a dishwasher. It
can cause damage to the nonstick
coating.
Clean the moisture from the cavity after
each use.
11.2 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
CAUTION!
Be careful when you remove
the shelf supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the removed accessories in the
opposite sequence.
11.3 Catalytic cleaning
The cavity is coated with a catalytic
enamel. It absorbs fat.
Before you turn on the Catalytic cleaning:
• remove all the accessories and
removable shelf supports.
• clean the oven floor with warm water
and mild detergent.
• clean the inner door glass with warm
water and soft cloth.
The Catalytic cleaning cannot start:
• If the shelf supports are not removed.
• if the oven door are not closed.
1. Set function:Catalysis.
2. Press to confirm.
The display shows the time of day and
the duration of cleaning.
You cannot change the duration of the
Catalytic cleaning. You can delay the
start of the cleaning with the function:
End Time.
The signal sounds at the end of cleaning.
The oven turns off.
3. Press any sensor field to stop the
signal.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.4 Removing and installing
the door
You can remove the door to clean it.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
A
3. Close the door until it is at an angle
of approximately 45°.
ENGLISH 19