User manual

11.3 Removing the shelf
supports
Before maintenance, make sure that the
appliance is cool. There is a risk of burns.
To clean the appliance, remove the shelf
supports.
1. Pull carefully the supports up and out
of the front catch.
2
3
1
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear catch.
Install the shelf supports in the opposite
sequence.
11.4 Steam Cleaning
Remove as much dirt as possible
manually.
Remove the accessories and the shelf
support to clean the side walls.
The steam cleaning functions support the
steam cavity cleaning of the appliance.
For a better performance you
should start the cleaning
function when the appliance
is cool.
The specified time is related
to the duration of the function
and does not include the time
required for cleaning of the
cavity by the user.
When the steam cleaning function is
active, the light is off.
1. Fill the water drawer to the maximum
level.
2. Choose the steam cleaning function in
the menu: Cleaning.
Steam Cleaning - the duration of the
function is around 30 minutes.
a) Activate the function.
b) An acoustic signal sounds when
the programme is completed.
c) Touch a sensor field to deactivate
the signal.
Steam Cleaning Plus - the duration
of the function is around 75 minutes.
a) Spray a suitable detergent
uniformly in the oven cavity on
both enamel and steel parts.
Before you start the cleaning
procedure, make sure that the
appliance is cold.
b) Activate the function.
After around 50 minutes an
acoustic signal sounds when the
first part of the programme is
completed.
c) Press
.
This is not the end of
the cleaning
procedure. Follow the
message in the
display to complete
the cleaning.
d) Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water or oven detergents to
clean the cavity.
e) Press .
The final part of the procedure
starts. The duration of this stage is
around 25 minutes.
3. Wipe the internal surface of the
appliance with a non-abrasive sponge.
You can use warm water to clean the
cavity.
4. Remove the remaining water from the
water drawer.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. To speed up the
drying you can heat up the appliance with
hot air at temperature 150 °C for
approximately 15 minutes. You can get
maximum effects of the cleaning function if
you manually clean the appliance
immediately after the function ends.
11.5 Cleaning Reminder
When reminder is displayed cleaning is
necessary. Perform the function Steam
Cleaning Plus.
www.electrolux.com28