User manual

Problem Possible cause Remedy
The descaling procedure is
interrupted before it finish-
es.
The function was stopped
by the user.
Repeat the procedure.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
You did not fill the water
drawer to the maximum lev-
el.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is
on a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roast-
ing pan on the first shelf po-
sition.
The cleaning function is in-
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in-
terrupted before it finishes.
The function was stopped
by the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the de-
tergent. Spray the deter-
gent evenly.
There is no good perform-
ance of the cleaning proce-
dure.
The initial oven cavity tem-
perature of the steam
cleaning function was too
high.
Repeat the cycle. Run the
cycle when the appliance is
cold.
There is no good perform-
ance of the cleaning proce-
dure.
You did not remove the
side grids before the start of
the cleaning procedure.
They can transfer heat to
the walls and decrease the
performance.
Remove the side grids from
the appliance and repeat
the function.
There is no good perform-
ance of the cleaning proce-
dure.
You did not remove the ac-
cessories from the appli-
ance before the start of the
cleaning procedure. They
can compromise the steam
cycle and decrease the per-
formance.
Remove the accessories
from the appliance and re-
peat the function.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
ENGLISH
33