User manual

If you do not use the

appliance for 3 minutes, the

brightness of the display

decreases to lower the power

consumption. When you

press a button, the display

goes back to the active

mode.

5.5 Buttons

Button Function Description

MINUS To set the time.

CLOCK To set a clock function.

PLUS To set the time.

6. CLOCK FUNCTIONS

6.1 Clock functions table

Clock function Application

TIME OF DAY To set, change or check the time of day.

DURATION To set how long the appliance operates.

END To set when the appliance deactivates.

TIME DELAY To combine DURATION and END function.

MINUTE MINDER To set countdown time. This function has no effect on the

operation of the appliance. You can set the MINUTE

MINDER at any time, also when the appliance is off.

6.2 Setting the time. Changing

the time

You must set the time before you operate

the oven.

The flashes when you connect the

appliance to the electrical supply, when

there was a power cut or when the timer

is not set.

In case of a power cut up to

1 hour, the time of day is

shown and flashes. Make

sure that the time is correct

and press to stop the

flashing.

In case of a power cut longer

than 1 hour, you must set the

time again.

Press the or to set the correct time.

After approximately five seconds, the

flashing stops and the display shows the

time of day you set.

ENGLISH