User manual
d) Wipe the internal surface of the
appliance with a non-abrasive
surface care sponge. You can use
warm water or oven detergents to
clean the cavity.
e) Press .
The final part of the procedure
starts. The duration of this stage is
around 25 minutes.
3. Wipe the internal surface of the
appliance with a non-abrasive sponge.
You can use warm water to clean the
cavity.
4. Remove the remaining water from the
water drawer.
After cleaning keep the appliance door
open for approximately 1 hour. Wait until
the appliance is dry. To speed up the
drying you can heat up the appliance with
hot air at temperature 150 °C for
approximately 15 minutes. You can get
maximum effects of the cleaning function if
you manually clean the appliance
immediately after the function ends.
11.5 Cleaning Reminder
When reminder is displayed cleaning is
necessary. Perform the function Steam
Cleaning Plus.
You can enable / disable the function:
Cleaning Reminder in the menu: Basic
Settings.
11.6 Cleaning the water drawer
Remove the water drawer from the
appliance.
1. Remove the lid of the water drawer.
Lift the cover in correspondence with
the protrusion in the rear.
XAM
2. Remove the wave-breaker. Pull it
away from the drawer body until it
snaps out.
3. Wash the water drawer parts with
your hands. Use tap water and soap.
Do not use abrasive
sponges. Do not put
water drawer inside a
dish washer.
After you clean the water drawer parts,
reassemble the water drawer.
1. Snap in the wave-breaker. Push it into
the drawer body.
2. Assemble the lid. First insert the front
snap and then push it against the
drawer body.
XAM
XAM
3. Insert the water drawer inside the
appliance.
4. Push the water drawer towards the
oven until it latches.
11.7 Steam generation system -
Descaling
When the steam generator operates, there
is an accumulation and deposition of
limestone inside because of calcium
contents in the water. This can have a
negative effect on the steam quality, on
the performance of the steam generator
and on the food quality. To prevent this,
clean the steam generation circuit from
residual stone.
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide you
through the procedure.
The duration of the complete procedure is
about 2 hours.
The light in this function is off.
ENGLISH
29