User manual

Problem Possible cause Remedy
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
You did not assemble the
wave-breaker correctly.
Assemble the wave-breaker
in the body of the water
drawer correctly.
The appliance does not re-
tain the water drawer after
you push it on the cover.
You did not fully press the
water drawer body.
Insert the water drawer
body in the appliance by
pushing it until it reaches to
the end.
The water drawer is difficult
to clean.
You did not remove the lid
and the wave-breaker.
Refer to "Cleaning the water
drawer".
The descaling procedure is
interrupted before it finish-
es.
There was a power cut. Repeat the procedure.
The descaling procedure is
interrupted before it finish-
es.
The function was stopped
by the user.
Repeat the procedure.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
You did not fill the water
drawer to the maximum lev-
el.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is
on a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roast-
ing pan on the first shelf po-
sition.
The cleaning function is in-
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in-
terrupted before it finishes.
The function was stopped
by the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the de-
tergent. Spray the deter-
gent evenly.
There is no good perform-
ance of the cleaning proce-
dure.
The initial oven cavity tem-
perature of the steam
cleaning function was too
high.
Repeat the cycle. Run the
cycle when the appliance is
cold.
There is no good perform-
ance of the cleaning proce-
dure.
You did not remove the
side grids before the start of
the cleaning procedure.
They can transfer heat to
the walls and decrease the
performance.
Remove the side grids from
the appliance and repeat
the function.
ENGLISH
33