User manual

WHAT TO DO IF…
CAUTION!
Before troubleshooting, disconnect
the power supply.
Only a qualified electrician or com-
petent person must do the trouble-
shooting that is not in this manual.
There are some sounds during nor-
mal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
The appliance is
noisy
The appliance is not sup-
ported properly
Check if the appliance
stands stable (all the four
feet should be on the floor)
The compressor op-
erates continually
The temperature is not set
correctly.
Set a warmer temperature
The lid has been opened
too frequently
Do not leave the lid open
longer than necessary
The lid is not closed prop-
erly
Check if the lid closes well
and the gaskets are undam-
aged and clean
Large quantities of food to
be frozen were put in at the
same time
Wait some hours and then
check the temperature again
Food placed in the appli-
ance was too warm
Allow food to cool to room
temperature before storing
The temperature of the
room that contains the ap-
pliance is too high for effi-
cient operation
Try to reduce the tempera-
ture in the room where the
appliance stands
Audible alarm and
flashing alarm sym-
bol
It is too warm inside the
freezer
Refer to "Excessive Temper-
ature Alarm" in "Control
Panel" chapter
The lid doesn't close
completely
The lid gaskets are dirty or
sticky
Clean the lid gaskets
Food packages are block-
ing the lid
Arrange the packages in the
right way, see the sticker in
the appliance
The lid is difficult to
open
The lid gaskets are dirty or
sticky
Clean the lid gaskets
The valve is blocked Check the valve
The lamp does not
work
The lamp is in stand-by. Close and open the lid.
The lamp is defective. Refer to "Replacing the
lamp"
It is too warm in the
freezer
The temperature is not set
correctly
Set a lower temperature
ENGLISH 15