User manual

Problem Possible cause Solution
The lamp does not work. The lamp is defective. Refer to "Replacing the
lamp".
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to "Operation" chap‐
ter.
Large quantities of food to
be frozen were put in at
the same time.
Wait some hours and then
check the temperature
again.
The room temperature is
too high.
Refer to climate class chart
on the rating plate.
Food placed in the appli‐
ance was too warm.
Allow food to cool to room
temperature before storing.
The lid is not closed prop‐
erly.
Check if the lid closes well
and the gaskets are un‐
damaged and clean.
The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem‐
perature.
This is normal, no error
has occurred.
The compressor starts af‐
ter a period of time.
Temperature cannot be
set.
The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower temper‐
ature.
The lid is not closed cor‐
rectly.
Refer to "Opening and
closing the lid".
The products' temperature
is too high.
Let the product tempera‐
ture decrease to room tem‐
perature before storage.
Many products are stored
at the same time.
Store less products at the
same time.
The lid has been opened
often.
Open the lid only if neces‐
sary.
The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
Products to be frozen are
placed too closely to each
other.
Make sure that there is
cold air circulation in the
appliance.
ENGLISH 13