User manual

Problem Possible cause Solution
The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
There is too much frost and
ice.
The lid is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Opening and clos-
ing the lid".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Temperature is set incor-
rectly.
Refer to "Operation" chap-
ter.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
This is normal, no error has
occurred.
The compressor starts after
a period of time.
Temperature cannot be set. The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The lid is not closed cor-
rectly.
Refer to "Opening and clos-
ing the lid".
The products' temperature
is too high.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time.
Store less products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The lid has been opened of-
ten.
Open the lid only if neces-
sary.
The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
Products to be frozen are
placed too closely to each
other.
Make sure that there is cold
air circulation in the appli-
ance.
8.2 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your appliance
which can be found either on the
guarantee certificate or on the rating plate
located on the external right side of the
appliance.
ENGLISH
11