User manual

Problem Possible cause Solution
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The lid has been opened of-
ten.
Open the lid only if neces-
sary.
The ActionFreeze function
is switched on.
Refer to "ActionFreeze
function".
Products to be frozen are
placed too closely to each
other.
Make sure that there is cold
air circulation in the appli-
ance.
8.2 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your appliance
which can be found either on the
guarantee certificate or on the rating plate
located on the external right side of the
appliance.
8.3 Replacing the lamp
WARNING!
Do not remove the lamp
cover at the time of
replacement. Do not operate
the freezer if the lamp cover
is damaged or missing.
1. Disconnect the mains plug from the
mains socket.
2. Replace the used lamp with a new
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the lamp
comes on.
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
CAUTION!
If you are discarding an old
appliance that has a lock or
catch on the lid, you must
ensure that it is made
unusable to prevent young
children being trapped inside.
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
www.electrolux.com12