User manual

g
127
The coffee flows out of only one of
the dispensers
• The dispenser holes are blocked.
0 Scrape off the dry coffee residues with
a needle (Fig. 29).
When the knob for steam and hot
water is turned, no steam comes out
of the steam nozzle
• The holes in the steam nozzle and the
inner part of the steam nozzle are
clogged.
0 Clean the holes in the steam nozzle
and the inner part of the steam nozzle
(see „Cleaning the steam nozzle“,
page 117).
When the or function is
selected, the appliance does not
deliver coffee, but only water
• The ground coffee may be blocked in
the ground coffee filler.
0 Remove the ground coffee inside the
filler using a knife (see „Using pre-
ground coffee“, page 115) (Fig. 22).
Then clean the brewing unit and the
inside of the appliance (see „Cleaning
the brewing unit“, page 123)
When the button is pressed, the
appliance does not switch on
• The main switch at the back is not
switched on (fig. 8) or the appliance is
not plugged in.
0 Check that the main switch is in the "I“
position and that the power cable is
plugged into the mains socket.
The brewing unit cannot be removed
for cleaning
• The appliance is on. The brewing unit
can only be removed if the appliance is
off.
0 Turn the appliance off and remove the
brewing unit (see „Cleaning the brew-
ing unit“, page 123).
3
Important: The brewing unit can only
be removed if the appliance is turned
off with the ON/OFF key at the
front. It should not be disconnected
from the mains. Attempting to
remove the brewing unit when the
appliance is on may cause serious
damage.
The coffee does not run out from
the dispenser outlets, but from
around the sides of the service door
• The holes in the dispenser outlets are
clogged with dry coffee.
0 Remove the dried coffee with a needle
(Fig. 29).
• The tilt compartment (R) inside the ser-
vice door is blocked and cannot swing.
0 Thoroughly clean the tilt compartment,
particularly near the hinges, to ensure
they are free to swing smoothly.
Ground coffee was used (not beans)
and the appliance does not deliver
any coffee
• Too much ground coffee has been
added.
0 Remove the brewing unit and thor-
oughly clean the inside of the appli-
ance, as described in „Cleaning the
brewing unit“, page 123. Repeat the
operation using a maximum of 2
scoops of ground coffee.
• The "Coffee strength / Pre-ground cof-
fee" knob has not been turned to the
or position and the appliance
has used both the ground coffee that
has been added and the coffee that has
been ground by the grinder.
0 Thoroughly clean the inside of the
appliance, as described in „Cleaning
the brewing unit“, page 123. Repeat
the operation, first turning the "Coffee
strength / Pre-ground coffee" knob as
described in „Using pre-ground cof-
fee“, page 115.
• Ground coffee has been added when
the appliance was switched off.
822_949_353 ECG6400_Elux.book Seite 127 Montag, 28. Januar 2008 11:57 23