User manual

9
9
Insert the filter (figure 1/E) in the filter
holder (figure 1/F). This product has
a permanent filter. If you want to use
a paper filter, take out the permanent
filter and insert the paper filter in the
filter holder
Fill in ground coffee.
Please use ground coffee, medium
grind. The quantity of coffee is matter
of personal taste. For an average
strong coffee one measuring spoon
(approx. 6-7g) is suf
ficient per cup.
Close the lid (Figur
e 1/D).
Place the coffee jug complete with lid
onto the warming plate.
Switch on the appliance with the
ON/OFF switch (Figure 1/A).
The pilot lamp lights up. After a few
seconds, hot water flows into the filter
When the water has stopped flowing,
the appliance automatically switches
to the warming mode.
After use the appliance must be
switched of
f by hand.
Remove the jug.
While boiling, the jug must not be
removed for longer than 30seconds
or the filter will overflow.
Once the jug has been removed,
the filter valve prevents coffee from
dripping onto the warming plate.
The warming plate always keeps the
coffee hot. It remains on until the
appliance is switched off with the
ON/OFF switch (Figure 1/A) and the
pilot lamp goes out.
To guarantee uniform coffee strength
it should be stirred in the coffee jug
after pr
eparation.
If the water has stopped flowing and
you wish to refill water for a fresh jug
of coffee, switch the appliance off and
allow it to cool down for a few minutes.
Cleaning and Care
Unplug the power cord from the mains
socket befor
e cleaning.
To clean the filter holder, swing up the
handle and remove the filter holder
(Figur
e 4).
To clean the filter valve thoroughly,
activate it several times while it is being
rinsed.
Replace filter holder and swing handle
down (Figur
e 4).
Clean the appliance with a damp cloth
but never immerse it in water
!
Coffee jug and jug lid are dishwasher
proof.
DESCALING - MAKING YOUR COFFEE
MAKER LAST LONGER
As a precautionary measure, we
recommend descaling every three months.
Only use an environmentally friendly
descaler and follow the instructions on the
packet. Please do not use a descaler with
a concentrated formic base, or any
descaler in powder form.
Fill the water reservoir with water and
only then add the descaler. Not vice
versa! Place the coffee jug with its lid
onto the warming plate. Allow the
descaler to take effect for about 15
minutes, then switch the appliance on.
Switch it off when the descaler solution
has finished flowing through.
If necessary repeat the descaling
process. Following this, allow the
appliance to run at least twice with
plain water. Thoroughly rinse the coffee
jug, lid and filter holder under running
water, activate the filter valve repeatedly
during the rinse process.