User manual

g
26
0 Select the desired temperature
and wait until the temperature con-
trol light goes out.
0 Press the steam jet button
(Fig. 1/F) several times with the
iron on the soleplate to prime the
pump.
3
If the water tank has run dry, it may
be necessary to re-prime the pump
after filling the steam iron with
water.
3
The steam iron is equipped with a
drip-stop system. This system
automatically stops water flowing
to the steam chamber should the
temperature fall too low to gener-
ate steam. This prevents dripping,
even at low temperatures.
Steaming hanging items of
clothing
3
The vertical steam jet function is
ideal for steaming curtains, suits
and delicate fabrics.
0 Hang the article concerned on a
hanger and hold the steam iron at a
distance of 10–20 cm from the
material.
0 Now press the steam jet button
(Fig. 1/F).
1
Do not attempt to freshen up clot-
hing whilst it is still being worn.
Risk of burning!
The safety auto-off feature
(not available with EDB7510)
For total safety and peace of mind,
the steam iron will automatically
switch itself off if left unattended
(EDB7520, EDB7530, EDB7540).
It will switch off if left in the ironing
position for 30 seconds (see Fig.
2/a). It will also switch off if left
unattended in the upright position
for 15 minutes (see Fig. 2/b). The
steam iron will also switch off if it is
knocked onto its side for
30 seconds (see Fig. 2/c).
Should you leave the steam iron
unattended, the red safety auto-off
light (Fig. 1/K, positioned on top of
the handle) will flash and a warning
beep will sound to alert you that
the auto-off function has been acti-
vated.
Power to the steam iron’s heating
element will be cut and the steam
iron will start to cool.
3
After the iron has cut-out, the
power ON light will remain illumi-
nated, as the steam iron is still
connected to the power outlet.
0 To reset the safety auto-off feature,
simply move the steam iron.
The power to the steam iron’s ele-
ment will then reconnect and it will
begin heating again. Wait until the
temperature control light goes out
before recommencing ironing.
Care and Cleaning
After each use
0 Turn the power off and remove the
plug from the power outlet.
0 Allow the steam iron to cool before
winding the cord around the built-
in cord wrap (Fig. 1/O).
Storage
0 Always store the steam iron on its
heel rest (see Fig. 3).
Do not store the steam iron with
the soleplate facing down, or in the
carton.
Cleaning
0 To clean the exterior of the steam
iron, wipe with a damp soft cloth
and wipe dry.
1
Do not use harsh abrasives, chem-
ical cleaners or solvents, as these
will damage the surface.
822 949 435_EDB75xx-EX.book Seite 26 Mittwoch, 5. November 2008 11:06 23