User manual

6
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
To access adjustment mode:
Turn the programme selector dial to switch on the
appliance. In selection mode press simultaneously
the buttons 3 and 6 until «
C0» appears on the digits.
Adjusting the level of conductivity:
Press button 5 sequentially: the level of conductivity
is indicated by the lighting of the horizontal hyphens
6
3
2
4
5
No
Buzzer
Delay
Start
Drying
Cooling
End
Full Tank
Low
Temperature
Add/
Clothes
Time
Save
AUTOSENSING
Start
Clogged Filters
Clogged
Condenser
6
3
12
4
5
COTTON
Extra dry
Ready to wear
Iron dry
Slightly damp
Store dry
Wring dry
Store
dry
Extra dry
Iron dry
TIMED
PROGRAMS
Add/
Clothes
No
Buzzer
Door
Delay
Start
Drying
Cooling
End
Full Tank
Off
Time
Save
Low
Temperature
60 min
Cooling
SYNTHETIC
Easy iron
90 min
30 min
1.25
Extra delicate
AUTOSENSING
Start
Clogged Filters
Clogged
Condenser
Normally, the appliance is factory-set to the highest
level; however, certain models may be configured
differently.
Memorizing the new setting:
Simultaneously press the buttons 3 and 6.
Press the buttons down until the pilot lights above
each ones stop flashing and the buzzer sounds.
Display
Conductivity
degree
Approximative
value (µ/cm)
CC 00
Low < 300
CC 00
Medium 300 - 600
CC 00
High > 600
125981910.qxp 2006-02-03 08:25 Page 6