User manual

12 electrolux use
“
EEnndd ooff pprrooggrraammmmee”” lliigghhtt
This light is on at the end of the cooling
phase, during the anti-creasing phase and at
the end of the programme.
“
WWaatteerr rreesseerrvvooiirr ffuullll””
”
lliigghhtt
This light indicates that the appliance is in the
drying phase
..
This light comes on at the end of the
programme to remind you that the water
reservoir must be emptied out. If this light
illuminates during a programme this means
that the water reservoir is full. The buzzer
sounds, the programme stops, the light of
the Start/Pause button flashes. This light
comes on also when the water reservoir is
not inserted correctly.
““FFiilltteerr cclleeaanniinngg”” lliigghhtt
This light illuminates at the end of the
programme to remind you that the
filters must be cleaned.
““CCoonnddeennsse
err cclleeaanniinngg”” lliigghhtt
It comes on every 80 cycles to remind you
that the condenser must be cleaned.
Cancelling a programme
Turn the selector dial to “O” to cancel
a programme which is running. Now
you can select a new programme.
At the end of the programme
If the laundry is not removed at the end
of the cycle, the dryer performs an
aannttii--
ccrreeaassiinngg
phase (duration: 30 minutes
maximum).
If you do not remove the laundry, the
dryer will stop automatically at the
end of the anti-creasing phase.
Lights End/Anticrease, and
remain lit and the buzzer sounds for
2 minutes.
Turn the programme selector dial to
““OO””
to switch the machine off. Remove the
laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Turn the programme selector dial to “
OO
”;
all the lights go out. The appliance is
switched off.
Remove the laundry.
IIff yyoouu ooppeenn aanndd tthheenn cclloossee tthhee ddoooorr
bbeeffoorree ttuurrnniinngg tthhee sseelleeccttoorr ddiiaall ttoo ““OO””
aallll tthhee lliigghhtts
s ccoorrrreessppoonnddiinngg ttoo tthhee
pphhaasseess mmaakkiinngg uupp tthhee ppeerrffoorrmmeedd
pprrooggrraammmmee ccoommee oonn..
AAfftteerr eeaacchh uussee
• Clean the filters.
• Empty the water reservoir.
IImmppoorrttaanntt!!
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
and wait until the end of this cooling
phase before removing the laundry. This
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
“
OO
” and then to Cooling and
depress Start button.
MMooddiiffyyiinngg tthhee pprrooggrraammmmee
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to “
OO
”. Select the
new programme and press the Start
button .