User manual

Problem Possible cause Remedy
Conductance of water at instal-
lation site differs from standard
setting of machine.
Re-programme standard set-
ting for degree of drying (see
‘Programming options’ chap-
ter).
Loading door does not close. Filter not in place. Install filter into place.
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or
higher drying level (e.g. EXTRA
instead of CUPBOARD ).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
MACHINE SETTINGS
BUZZER SIGNAL PERMANENT OFF
1. Turn the programme selector to any
programme.
2. Press simultaneously the DELICATE
and LONG ANTICREASE buttons and
hold down for approx. 5 seconds.
3. The buzzer is by default always off. You
can use BUZZER button to activate or
deactivate sound but machine does not
memorize your selection.
WATER HARDNESS
Water contains, a variable quantity of lime-
stone and mineral salts of which quantities
vary according to geographical locations
thus varying its conductivity values. Rele-
vant variations of the conductivity of the
water compared to those prefixed by the
factory could slightly influence the residual
humidity of the laundry at the end of the cy-
cle. Your dryer allows you to regulate the
sensitivity of the drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any
programme.
2. Press simultaneously the LONG ANTI-
CREASE and START/PAUSE buttons
and hold down for approx. 5 seconds.
The current setting is on the lights:
END/ANTICREASE – low conductivity
<300 micro S/cm, COOLING – medium
conductivity 300-600 micro S/cm,
COOLING and END/ANTICREASE –
high conductivity >600 micro S/cm
3. Press the START/PAUSE button se-
quentially until you set desired level.
4. To memorize setting press simultane-
ously the LONG ANTICREASE and
START/PAUSE buttons or turn knob to
"O" (OFF) position
TECHNICAL DATA
Dimensions (mm) Width / Height / Depth 850 x 600 x 580
Max. depth
(with the appliance door open)
1090 mm
Max. width
(with the appliance door open)
950 mm
Electrical connection Voltage 220 V
Frequency 60 Hz
Fuse 10 A
Total power 2200 W
Drum volume 108 l
electrolux 11