User manual

The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the BUZZER button)
is pressed, led START/PAUSE button
starts flashing temporarily in yellow.
The drying programme is not however
affected by this (laundry protection).
DRYING CYCLE COMPLETE /
REMOVING LAUNDRY
Once the drying cycle is complete, the
lights END/ANTICREASE and FILTER
are on. If the buzzer function is active, an
acoustic signal will sounds intermittently for
about one minute.
The drying cycles are automatically fol-
lowed by an anti-crease phase which
lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free of
creases. The laundry can be removed
at any time during the anti-crease
phase. (The laundry should be taken
out towards the end of the anti-crease
phase at the latest to prevent creases
from forming.) If LONG ANTICREASE
function has been selected, the anti-
crease phase is lengthened by 60 mi-
nutes.
1. Open door.
2. Remove laundry.
3. Remove filter after clothes has been re-
moved. Clean the filter.
Warning! Before You place the filter,
please check it there is nothing inside
the filter seat.
4. Turn the programme selector to "O"
(OFF).
Important! Clean the filter after each drying
cycle.
5. Close the door.
CLEANING AND MAINTENANCE
Warning! The tumble dryer is not to be
used if industrial chemicals have been
used for cleaning!
CLEANING FLUFF FILTER
The filter collect all the fluff which accumu-
lates during drying. To ensure that the dryer
works perfectly, the fluff filter must be
cleaned after every drying cycle.
The warning light FILTER
, is on to re-
mind you this operation.
Caution! Never operate the dryer
without fluff filter or with damaged or
blocked fluff filter.
1.
Open loading door and remove laun-
dry.
2. Remove the filter which is built into the
lower part of the loading aperture.
electrolux 9