User manual

TIJD (Time)
Use the Time (Time) button to select the pro-
gramme duration after setting the TIME pro-
gramme. You can select a programme du-
ration from 20 min. to 3 hours in 10-minute
steps.
1. Turn the programme selector to the TIJD
(Time) programme.
2. Press the TIJD (Time) button repeatedly
until the desired programme duration is
shown in the display, e.g.
for
a programme of 20 minutes.
If the programme duration is not selected,
the duration is automatically set to 10 mins.
STARTUITSTEL (Delay start)
With the STARTUITSTEL (delay) button,
you can delay the start of a programme
by between 30 minutes (30') and a max-
imum of 20 hours (20h).
1. Select the programme and additional
functions.
2. Press the STARTUITSTEL (Delay) button
as many times as necessary until the re-
quired time of the delay appears on the
display, e.g.
H if the programme
is to be started in 12 hours.
If the display is showing H and
you press the button again, the time de-
lay will be cancelled. The display will
show 0 and then the duration of the se-
lected programme.
3. To activate the delay timer, press the
START/PAUZE (Start/Pause) button. The
amount of time remaining until the pro-
gramme is set to start is continuously dis-
played (e.g. 15h, 14h, 13h, … 30' etc).
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme knob. The child
lock can be activated or deactivated by hold-
ing down the ZOEMER (BUZZER) and TIJD
(TIME) buttons simultaneously for 5 seconds.
– Before programme is started: Appli-
ance cannot be used
– After programme is started: Pro-
gramme in operation cannot be
changed
The
icon appears in the display to indicate
that the child safety device is activated.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the START/PAUZE (START / PAUSE)
button. The programme is started.
The programme phase is shown in display by
appropriate icons. From left to the right, from
drying
,anticrease , to cooling .
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
" O" -OFF position. The programme is can-
celled.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the ZOEMER button)
is pressed, led above START/PAUSE
button starts flashing temporarily in yel-
low. The drying programme is not how-
ever affected by this (laundry protection).
Drying cycle complete / removing
laundry
Once the drying cycle is complete, display
shows a blinking " 0 ", under anti-crease
and filter icon appear dash. If the ZOEM-
ER (Buzzer) button has been pressed, an
acoustic signal sounds intermittently for
about one minute.
10 electrolux