User manual

Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme time is corrected
automatically depending on
type and volume of laundry and
level of dampness.
Automatic process; this is not a
machine fault.
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Select time programme or high-
er drying level (e.g. EXTRA
DROOG(EXTRA DRY) instead of
KASTDROOG (STORAGE
DRY) ).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Changing the bulb for interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force cen-
tre.
Warning! When the appliance is
switched on, the interior lighting
switches itself off after 4 minutes when
the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug.
1. Unscrew cover above the bulb (this can
be found directly behind the loading aper-
ture, at the top; refer to “Description of
machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light cov-
er. Do not operate the dryer when missing o-
ring gasket on door light cover.
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
Machine settings
ZOEMER SIGNAL permanent off
1. Turn the programme selector to any pro-
gramme.
2. Press simultaneously theANT-IKREUK
(LONG ANTI-CREASE) and ZOEMER
(BUZZER) buttons and hold down for ap-
prox. 5 seconds.
3. The buzzer is by default always off. You
can use ZOEMER button to activate or
deactivate sound but machine does not
memorize your selection.
Water hardness
Water contains, a variable quantity of lime-
stone and mineral salts of which quantities
vary according to geographical locations
thus varying its conductivity values. Relevant
variations of the conductivity of the water
compared to those prefixed by the factory
could slightly influence the residual humidity
of the laundry at the end of the cycle. Your
dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity val-
ues of the water.
1. Turn the programme selector to any pro-
gramme.
2. Press simultaneously the ZOEMER (BUZ-
ZER) and START/PAUZE (START
PAUSE) buttons and hold down for ap-
prox. 5 seconds. The current setting is on
the display:
– low conductivity
<300 micro S/cm,
– medium
conductivity 300-600 micro S/cm,
– high conductivity >600 micro
S/cm
3. Press the START/PAUZE (START
PAUSE) button sequentially until you set
desired level.
4. To memorize setting press simultaneous-
ly the ZOEMER (BUZZER) and START/
electrolux 13