User manual
Table Of Contents
- INHOUDSOPGAVE
- 1. VEILIGHEIDSINFORMATIE
- 2. VEILIGHEIDSVOORSCHRIFTEN
- 3. BESCHRIJVING VAN HET PRODUCT
- 4. BEDIENINGSPANEEL
- 5. PROGRAMMATABEL
- 6. OPTIES
- 7. INSTELLINGEN
- 8. VOOR HET EERSTE GEBRUIK
- 9. DAGELIJKS GEBRUIK
- 10. AANWIJZINGEN EN TIPS
- 11. ONDERHOUD EN REINIGING
- 12. PROBLEEMOPLOSSING
- 13. TECHNISCHE GEGEVENS
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMME TABLE
- 6. OPTIONS
- 7. SETTINGS
- 8. BEFORE FIRST USE
- 9. DAILY USE
- 10. HINTS AND TIPS
- 11. CARE AND CLEANING
- 12. TROUBLESHOOTING
- 13. TECHNICAL DATA
- TABLE DES MATIÈRES
- 1. CONSIGNES DE SÉCURITÉ
- 2. INSTRUCTIONS DE SÉCURITÉ
- 3. DESCRIPTION DE L'APPAREIL
- 4. PANNEAU DE COMMANDE
- 5. TABLEAU DES PROGRAMMES
- 6. OPTIONS
- 7. RÉGLAGES DE BASE
- 8. AVANT LA PREMIÈRE UTILISATION
- 9. UTILISATION QUOTIDIENNE
- 10. CONSEILS
- 11. ENTRETIEN ET NETTOYAGE
- 12. EN CAS D'ANOMALIE DE FONCTIONNEMENT
- 13. CARACTÉRISTIQUES TECHNIQUES
- INHALTSVERZEICHNIS
- 1. SICHERHEITSHINWEISE
- 2. SICHERHEITSANWEISUNGEN
- 3. GERÄTEBESCHREIBUNG
- 4. BEDIENFELD
- 5. PROGRAMMTABELLE
- 6. OPTIONEN
- 7. EINSTELLUNGEN
- 8. VOR DER ERSTEN INBETRIEBNAHME
- 9. TÄGLICHER GEBRAUCH
- 10. TIPPS UND HINWEISE
- 11. REINIGUNG UND PFLEGE
- 12. FEHLERSUCHE
- 13. TECHNISCHE DATEN
11.5 Cleaning the control panel
and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion to
clean the appliance.
11.6 Cleaning the airflow slots
Use a vacuum cleaner to remove the fluff
from the airflow slots.
12. TROUBLESHOOTING
Problem Possible solution
You cannot activate the appliance. Make sure that the mains plug is connec-
ted to the mains socket.
Check fuse in fuse box (domestic installa-
tion).
The programme does not start. Press Start/Pause.
Make sure that the appliance door is
closed.
The appliance door does not close. Make sure that the installation of the filter
is correct.
Make sure that the laundry does not catch
between the appliance door and the rub-
ber seal.
The appliance stops during operation. Make sure that the water container is emp-
ty. Press Start/Pause to start the pro-
gramme again.
The display shows a long programme du-
ration.
1)
Make sure that the weight of the laundry is
applicable to the duration of the pro-
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Make sure that the room temperature is
not too warm.
The display shows a short programme du-
ration.
Set the Time Drying or the Extra Dry pro-
gramme.
The display shows Err. If you want to set a new programme, de-
activate and activate the appliance.
www.electrolux.com32