User manual

3
Description of the cooker hood
The cooker hood Functions
There are two possible systems:
• Extraction of air to outside using optional venting kit
and evacuation duct (remove the carbon filter).
• Recirculation using carbon filter (already fitted with
the hood).
The cooker hood cannot be connected to flues
of other appliances that run on energy sources
other than electricity. Please, keep to the
provisions of official directives regarding the
question of fumes discharge.
Accessories
The following are included with the cooker hood (Fig. 1):
• Screws for mounting
• Template
• Non return fume valve (mounted in the outlet hole)
Using the cooker hood
Fig. 1
1 Control panel
2 Grease filter
3 Lamps
4 Chimney
The control panel
Best results are obtained by using low speed for normal
conditions and high speed when smells and steam are more
concentrated.
Turn the hood on a few minutes before you start cooking
then you will get an underpressure in the kitchen. It should
be left on after cooking for about 15 minutes or until all
steam and smells have disappeared.
See below list and Fig. 2 to know the functions of the
Control Panel
A – Motor OFF button
B – ON button and motor speed selection button 1 - 2 - 3 -
1 -2- . . . .
E – Speed 1 LED
F – Speed 2 LED and grease filter saturation LED (flashes)
C – Speed 3 LED and carbon filter saturation LED
(flashes)
D – Intensive speed indicator LED
G – Intensive speed ON switch
H – OFF lamp button
I – ON lamp button
If the hood fails to operate correctly, briefly disconnect it
from the mains power supply for almost 5 sec. by pulling
out the plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
Intensive speed button
This speed should be used when the concentration of
cooking fumes or odours is particularly strong (for
example when frying, cooking fish etc.).
The fast speed will run for about 5 minutes and then
return to the speed previously set automatically (1, 2 or
3), or switch off if no speed was selected. To turn off the
fast speed, before the end of the 5 minutes, press button
A or button B.
Control devices for the grease
filter and carbon filter
This hood has a device which warns you when to clean
the grease filter or replace the carbon filter (in the case
of the air recircultion version).
This hood is delivered with a carbon filter. For
this reason we suggest to connect the warning signal to
replace the carbon filter.
If the hood will be used for recirculation of air, with
carbon filter, the warning signal have to be connected
as follows: Press the buttons B and G at the same time
for
about 3 seconds. The LED marked F lights up. When
the
LED marked C lights up, the warning signal is
connected.
To disconnect the warning signal, press the buttons
B and G at the same time for about 3 seconds until the
LED marked C goes out.
1
4
3
2
3
3
3
OO123 I
FC
ABEFCG HID