User Manual EFC 928 GB
Contents Safety instructions ................................................................ 2 Description of the cooker hood ............................................ 3 Using the cooker hood ......................................................... 3 Maintenance and cleaning ................................................... 4 If the hood does not function ............................................... 5 Technical data ......................................................................
Description of the cooker hood The cooker hood 1 Control panel 2 Grease filter 3 Lamp 4 Chimney 1 4 3 2 2 2 Fig. 1 Accessories The following are included with the cooker hood (Fig. 1): • Screws for mounting • Template • Non return fume valve (mounted in the outlet hole) Functions There are two possible systems: • Extraction of air to outside using optional venting kit and evacuation duct • Recirculation using carbon filter.
Using the cooker hood The control panel Best results are obtained by using low speed for normal conditions and high speed when smells and steam are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all steam and smells have disappeared. The control panel is located on the front right side = Lighting, on/off.
Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. Clean the filter regularly. The grease that collects in the filter and the duct could ignite if a hot plate is left on (or if overheating occurs). Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products.
If the hood does not function Before calling for service Check the plug is correctly connected to the wall socket. Check the fuse. Do not attempt any repairs yourself that are likely to lead to further damage. If the problem remains, contact your dealer or an approved service company. Remember to save your purchase receipt and warranty card (only used in some countries). Service and spare parts Your dealer or service company will supply you with service and spare parts.
Mounting the cooker hood - Fig. 5 • Rest the template correctly against the wall. The lower corner of the template corresponds to the lower corner of the extractor hood. Fig. 3. • A cross is marked on the template to indicate the centre. Mark this point on the wall. Fig. 3. Fig. 6 • Drill two holes (Ø 8 mm) in the wall at the points indicated, insert the stops (Ø 8 mm) and screw in the hooks provided. Fig. 3. • Hang the hood and adjust its position using the screws on the hooks. Fig. 4.
• Remove the telescopic chimney support M by unscrewing the side screws R (one on each side - these screws must be kept). Fig. 6. • Remove the air pipe L from the telescopic chimney support M; to do this, unscrew the four screws (Ø 2,9 x 9,5 mm) fixing the air pipe to the support (these screws must be kept). Fig. 6. • Fit the telescopic chimney support to the wall, at a point close to the ceiling.
LI1REA Ed.
