User manual

• Remove the telescopic chimney support M by

unscrewing the side screws R (one on each side - these

screws must be kept). Fig. 6.

• Remove the air pipe L from the telescopic chimney

support M; to do this, unscrew the four screws (Ø 2,9 x

9,5 mm) fixing the air pipe to the support (these screws

must be kept). Fig. 6.

• Fit the telescopic chimney support to the wall, at a point

close to the ceiling. The telescopic chimney support has

a reference mark P, which must coincide with the line

that you have already drawn on the wall. Fig. 6.

• Using a pencil, mark the two holes required to fix the

support, and drill the holes (Ø 8 mm). Fig. 6.

• Insert two plugs and fix the telescopic chimney support

M using 2 screws size (5x45 mm). Fig. 6.

• During installation the plug must not be connected to

the power supply.

Select the hood operating mode

• Extractor operation

Fix the 150 mm diameter ABS pipe to the hood outlet

and ensure that the other end discharges into the open

air.

• Filter operation

If the connector ring has not yet been installed, it must

be fitted at this point (Q in Fig. 7, bayonet connector).

Turn it in a clockwise direction and fix it to the air pipe

L using a screw. Insert the air pipe into the telescopic

chimney support and fix it with four screws (Ø 2,9 x 9,5

mm). Fig. 7.

Fix the 150 mm diameter ABS pipe to the hood outlet,

and connect it to the air pipe connector ring.

For both versions:

• The hood can now be connected to the power supply.

• If a gas non-return valve has been installed or is required,

ensure that it opens and closes properly.

• Fix the top part the telescopic outlet pipe to the relative

support, using the two 3 mm dia x 9 mm screws R. Fig. 6.

• Slide the bottom part of the telescopic outlet pipe

downward until it rests in its housing on the top of the

hood.

• Replace the grease filters.