User manual

1. Control panel

2. Operating light

3. Grease filters

Standard accessories included:

● Screws for mounting

● Template for wall mounting

● No return valve (mounted on air outlet)

Mounting of grease filters

Attention! The grease filters are supplied not

mounted and packed in order to avoid damages

during transport of the hood.

● Fit the pins of the filter on the slots of the grease

filter housing (a), then use the handles of the

filter to lock them (b).

Dismount the filter the opposite way.

● Pull the handles backwards (c) to loosen the

filter (d) (Fig. 1).

Function

The hood may be used as follows:

- Exhausting version

- Recycling version

Attention! The Cooker hood is ready to be used for

air recycling (carbon filter already mounted in

place).

Exhausting version

The air is vented outdoors by a 150 mm duct

which must be connected to connecting ring

with no return valve on top of the motor

package.

The hood cannot be connected to

flues of other appliances that run

on energy sources other than

electricity. Please, keep to the provisions of official

directives regarding the question of fumes

discharge.

Recycling version

The air is filtered through a carbon filter and

recirculated into the room through the top sides of

the chimney (Fig. 2).

This version is used when there is no exhaust duct

for venting outdoors or when it is impossible to

install one.

Description of the appliance

Fig. 1

Fig. 2