User manual

• connect duct and cables and then mount again the chimney.

3.4 GENERAL WARNING

The pipe must be heat, flame and corrosionproof. The producer strongly advises against the

use of reducers or pipes with smaller diameter to the hood outlet pipe. Also flexible aluminium

pipes are not recommended because performance is strongly diminished.

The end part of the pipe, on the outside of the hole on the wall, must be of such a shape to

avoid rain, gusts of wind or other foreign bodies getting into the pipe. Should there be any

doubt, contact anyone specialising in the installation of gas or ventilation system.

4 ELECTRICAL CONNECTION

4.1 WARNING

The electrical connection can only be carried out by qualified professional personnel, using

standard material and state of the art installation methods. The manufacturer declines any

responsibility for installations carried out by unskilled persons and for installations which are

not in conformity with the standard norms concerning electrical safety (both concerning

methods and materials).

4.2 ELECTRICAL TECHNICAL DATA

The electrical technical data are visible inside the hood after the removal of the grease filters.

4.3 CONNECTION TO THE POWER SUPPLY

The flexible feed cable supplied is already connected internally and emerges from the hood

near the air outlet duct.

It is possible to effect two types of electric installation:

• fixed installation;

• installation by means of plug on a socket.

4.4 BEFORE ELECTRICAL INSTALLATION

Before connection you must:

• check that the electrical data indicated are in conformity with the main voltage and

frequency values of the building where the hood is to be installed;

• check that the building is fitted with electric safety systems to protect against short circuits

and electric shock systems, according to the laws in force;

• install an electric socket (or connection point) with a bipolar switch, which has contacts

with an opening of at least 3 mms;

• if it is intended to install the hood with a plug, it is necessary that you have access to the

plug.

• always turn off the main voltage supply by means of the bipolar switch before connecting

and switch on again only when connections have been completed, tested and are safe.