User manual

31
8.2.2 CARBON FILTERS THAT CANNOT BE REGENERATED
WARNING: (FOR CARBON FILTERS THAT CANNOT BE REGENERATED)
WE RECOMMEND REPLACING CARBON FILTERS AFTER APPROX. 200-300 HOURS
OF USE OF THE HOB.
CARBON FILTERS CANNOT BE WASHED OR RE-CYCLED. THEY MUST BE
REPLACED WHEN THEY WEAR OUT.
Carbon Filters do not guarantee the interchange of oxygen in the air.
To ensure correct ventilation and air interchange in the kitchen, national and international
regulations exist, which should be respected.
The manufacturer denies any responsibility for fires caused by failure to replace the
carbon filters.
8.3 REPLACEMENT OF LAMPS
WARNING! Always replace the lamps with lamps which have the same electrical
characteristics (see TECHNICAL DATA). Before replacing the lamps, make sure that they are
cold and that power has been completely turned off.
To replace a halogen lamp with a fixed lamp proceed as follows (see FIG.10):
• dismantle the lamp frame by means of a screwdriver, making sure that the glass does not
fall;
• take the faulty lamp out;
• take a new lamp, avoid touching it directly with your fingers, i.e. wrap it in paper;
• insert the two gudgeons into the holes;
• mount back the lamp frame.
9 CLEANING
To preserve the hood in good condition, clean this periodically following the advice given as
follows.
WARNING! Make sure that power has been completely turned off.
The detergent solution recommended is a combination of WATER and NEUTRAL LIQUID
SOAP. It is of vital importance that the liquid soap should not contain any grains which could
scratch the surface.
The solution should be applied first onto a soft cloth which is then rubbed over the shell. It is
important to follow the pattern of the satin finish with the cloth (see FIG.11).
IT IS ABSOLUTELY FORBIDDEN TO POUR LIQUIDS DIRECTLY ONTO THE HOOD.
The cloth used should not have any buttons, zips, fasteners or anything else which could
scratch the surface.
The use of harsh abrasive or granular products, petrol, spirits or similar products which
could damage the surface of the materiall, is severely forbidden.
The manufacturer will not be responsible for any damages either functional or to the
appearance of the hood, caused by cleaning operations carried out using unsuitable
products or unsuitable methods.