Installation Guide

8
Installation Instructions
4-wire receptacle
(NEMA type 14-30R)
Neutral
(WHITE wire)
30 AMP
NEMA 14-30
Ground
(GREEN wire)
Electrical connection (non-Canada) - 4 wire cord
1 Turn off power supply to outlet.
2 Remove the three screws securing the terminal block
access cover in the upper corner on the back of the
dryer.
3 Disconnect the internal (WHITE) dryer harness ground
wire from the (GREEN) ground screw next to the terminal
block.
4 Using an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 14-30 type ST or SRDT, attach the ground
(GREEN) power cord wire to the cabinet with the ground
(GREEN) screw. Tighten the screw securely.
7 Reinstall the terminal block cover.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could
result in personal injury or even death.
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/conductor at
connections.
WARNING
ELECTRICAL SHOCK HAZARD
Do not operate dryer without terminal cover in place. A
correctly installed terminal block cover also acts a qualified
strain relief for the power cord.
access cover
screw
terminal cover
DO NOT
REMOVE THIS
SCREW
access cover
screw
access cover
screw
line 2 - L2
(BRASS terminal)
move internal ground
wire to the center
terminal for 4-wire
system
route cord here
neutral - N
(SILVER terminal)
line 1 - L1
(BRASS terminal)
5 Move the internal dryer harness ground (WHITE) wire to
the terminal block and attach it along with the neutral
(WHITE) power cord wire conductor to the center,
SILVER colored terminal on the terminal block. Tighten
the screw securely.
6 Attach the RED and BLACK power cord conductors to
the outer, BRASS colored terminals on the terminal block.
Tighten both screws securely.
NOTE
Terminal screws were shipped from the factory temporarily
attached inside the access cover.
neutral
terminal
GREEN
ground wire
BLACK
or RED
power wire
BLACK
or RED
power wire
WHITE
neutral wire
GREEN
ground screw