User manual

1. Suction grid with grease filter

2. Work light

3. Light switch

4. Motor speed switch

5. Bracket

Standard accessories included:

● Template for mounting on wall and under

cupboard

● Screws:

● Duct with no return valve

● Cover for unused outlet hole

● Bracket

Function

The hood may be used as follows:

- For air exhausting

- For air recycling

Exhausting

The appliance has two exhaust outlets; D and E

(Fig. 2).

Important! To use the back hole E, remove air

switch F from the top hole.

Connect the hood to the smoke exhaust hose by

using the connecting ring G with no return valve

(bayonet coupling).

Insert plug H in the unused exhaust hole (bayonet

coupling).

Plug H is for closing the unused hole.

Attention! In the horizontal runs the duct must be

slightly slanted (about 10°) and directed upwards to

vent the air easily from the room to the outside.

The hood cannot be connected to flues

of other appliances that run on energy

sources other than electricity.

Please keep to the provisions of official directives

regarding the question of fumes discharge.

Recycling

The air is filtered through a carbon filter and

recirculated into the room through the front grid

(fig. 3).

This version is used when there is no exhaust duct

for venting outdoors or when it is impossible to

install one.

Description of the appliance

Fig. 2

Fig. 3

Fig. 1