User manual

29
Unpacking
Check that the cooker hood has no damages. Trans-
portation damages should immediately be reported to
the one responsible for the transport Damages, faults
and eventually missing details should immediately be
reported to the seller.
Take care of the packing material so that small
children cannot play with it.
Placement
The hood is to be mounted on the wall or under a
wall cupboard.
When installed, the hood must be not less than 60
cm. above electric burners or 70 cm. above gas or
mixed-fuel burners. (Fig. 4).
Before mounting the hood
Place the metal stops on the rear square holes Q.
Fix the bracket with two screws.
Electrical connection
The hood has a power cord with moulded plug with
earth connection to be connected to a wall outlet of
230 V.
The power cord length is 1,2 m.
Mounting of hood on wall
● Fix the drilling template to the wall (Fig. 5).
● Make 3 Ø 8 mm holes in the wall. 2 at points I, 1
as desired at points L.
● Insert the three Ø 8 mm expansion plugs into the
wall.
● Insert 2 5x45 screws at points I but do not tighten
them completely.
● Open the grid.
● Fit the hood into holes I, tighten the 2 screws.
● From inside the hood, insert the third 5x45 screw
into hole L (Fig. 6).
Installation
Special accessories
Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.
Order by the retailer
PNC 942 120 180
Fig. 4
Min
70 cm
Min
60 cm
Fig. 5
Fig. 6
H
H
I
I