User manual

7. Building In

A = Auxiliary burner SR = Semirapid burner

R = Rapid Burner

These hobs can be inserted in a built-in kitchen unit

whose depth is between 550 and 600 mm. The hobs

dimensions are shown in Fig. 9.

The edge of the cut out must have a minimum distance

from the rear wall of 55 mm.

If there are side walls, or sides of the furniture unit near

the hob, the cut out edges must have a minimum

distance of 100 mm.

Hanging forniture units or hoods must be placed at 650

mm. minimum from the hob.

a) Sealing gasket

FITTING THE HOB TO THE WORKTOP

Before fitting the hob into the cut out, an adhesive seal

must be fitted to the underside outside edge (Fig. 9) of

the hob. It is essential that no gaps are left in this seal

in order to prevent spillage near the hob seeping into

the cabinet below.

1) Remove the pan supports, the burners caps and

crowns and turn the hob upside down, taking care the

ignition candles are not damaged in this operation.

2) Place the sealing gasket all around the glass top

edge as shown in Fig. 9.

3) Fit the hob in the cut out and push it down until the

glass top and the working top come in touch, as shown

in Fig. 10.

Fig.9

Fig.10

FO 2108

FO 2107

550

470

580

510

55 min.

Fig. 8

FO 2109