User manual

If the burner accidentally
goes out, turn the control
knob to the off position and
try to light the burner again
after minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
The hob is supplied with the
progressive valves. They
make the flame regulation
more precise.
5.3 Turning the burner off
To put the flame out, turn the knob to the
off position
.
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.
6. USING THE ACCESSORIES
WARNING!
Refer to Safety chapters.
6.1 Using the bridge burner
CAUTION!
Always place the burners
before turning on the hob.
1. Remove the pan supports.
2. Remove the burner caps and crowns.
3. Use the bridge burner in 4 different
combinations.
• Put both bridge caps on the both
bridge burner crowns.
• Put one bridge cap and crown on
the front position and normal
sized cap and crown on the rear
position.
• Put one bridge cap and crown on
the rear position and normal sized
cap and crown on the front
position.
• Put both normal sized caps on the
both normal sized burner crowns.
After each combination put the pan
supports on the hob surface.
ENGLISH 13