User manual

CAUTION!
In the absence of electricity
you can ignite the burner
without electrical device; in
this case approach the
burner with a flame, turn the
control knob counter-
clockwise to maximum gas
supply position and push it
down. Keep the control knob
pushed for equal or less
than 10 seconds to let the
thermocouple warm up.
If the burner accidentally
goes out, turn the control
knob to the off position and
try to light the burner again
after minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
5.3 Turning the burner off
To put the flame out, turn the knob to the
off position .
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.
5.4 Before first use
Put a cookware containing water on each
electric cooking zone, set the maximum
position and operate the hob for 10 min.
This is to burn off the residue in the
appliance. After that, operate the hob at
minimum position for 20 min. During this
period, an odour and smoke can occur.
This is normal. Make sure that the airflow
is sufficient.
To operate electric cooking zone
properly, refer to diagram below.
5.5 Examples of cooking
applications for the electric
cooking zone
Heat
set‐
ting:
Application:
1 Keeping warm
2 Gentle simmering
3 Simmering
4 Frying / browning
5 Bringing to the boil
6 Bringing to the boil / quick fry‐
ing / deep-frying
5.6 Using the rapid hot plate
A red dot in the middle of the plate
shows a rapid hot plate. A rapid hot plate
heats up faster than usual plates. The
red dots are painted on the plates. They
can deteriorate during use and even
disappear completely after a period of
time. It does not have an effect on the
performance of the hob.
6. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
6.1 Cookware
Electric:
www.electrolux.com32