User manual

electrolux 7
Operation
Hob burner control knobs
The symbols on the knobs mean:
= no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before
putting a pan on the pan support.
Lighting the burners
To light a burner, turn the relevant
knob anticlockwise to maximum
position ( ) and push down the knob
to ignite.
Check the flame is regular and
adjust it as required.
If you cannot light the flame even
after several attempts, check the "cap"
(Fig - A) and “crown” (Fig - B) are in
the correct position.
In the absence of electricity, ignition
can occur without the electrical device;
in this case approach the burner with a
flame, push the relevant knob down and
turn it anti-clockwise until it reaches the
"maximum" position.
To switch off burners
To put the flame out, turn the knob to
the symbol ( ).
Take care when frying food in
hot oil or fat, as the overheated
splashes could easily ignite.
When switching on the mains, after
installation or a power cut, it is quite
normal for the spark generator to
be activated automatically.
)
)
A - Burner cap
B - Burner crown
C - Ignition candle
Do not keep the control knob
pressed for more than 15
seconds.
If the burner does not light
even after 15 seconds, release
the control knob, turn it the
"off" position and wait for at
least one minute before trying
to light the burner again.
If the burner accidentally goes
out, turn the control knob to
the "off" position and wait for
at least 1 minute before trying
to light the burner again.
Make sure pots do not protrude
over the edges of the cooktop and
that they are centrally positioned on
the rings in order to obtain lower gas
consumption.