User manual

9
Fitting the hob to the worktop
Before fitting the hob into the cut out, a sealing gasket
supplied with the hob must be fitted to the edge of the
cut out. It is essential that no gaps are left in this seal in
order to prevent spillage near the hob seeping into the
cabinet below.
1) Place the sealing gasket all around the edge of the
cut out.
2) Place the hob into the cut out and secure it by means
of the relevant fixing clamps and screws, as shown
in the diagram.
3) Remove the excess seal
The edge of the hob forms a double seal which prevents
the ingress of liquids.
FO 0199
a
Seal
30
20 min
60
a
b
FO 1013
3
Dimensions are given in mm.
Building In
Building over a cupboard or
drawer
If the hob is to be installed above a cupboard or drawer
it will be necessary to fit a heat resistant board below
the base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical
connection to the hob as shown in diagrams 1 and 2.
Building over a kitchen unit with
door
Proper arrangements must be taken in designing the
furniture unit, in order to avoid any contact with the
bottom of the hob which can be heated when it is
operated. The recommended solution is shown in
diagram 3.
The panel fitted under the hob ("a") should be easily
removable to allow easy access if technical assistance
is needed. The space behind the kitchen unit ("b") can
be used for connections.
ON/OFF SWITCH
FLEX
OUTLET
ON/OFF SWITCH
FLEX
OUTLET
FO 0763
FO 0764
1
2
860
500
R 60
20
830
470
55 min.
117
Cut Out Size
The dimensions of the cut-out are given in the diagram.
FO 2407