User manual

Install the heating element correctly
above the supports on the inner
walls of the appliance.
2.
Install the shelf supports.
REMOVING / INSERTING THE
DOOR
To clean the door remove it.
A
A
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Removing the door
1.
Open the door as far as it goes.
2.
Press down the clamping levers (A) on
the two door hinges.
45°
3.
Close the door until it is at an angle of
approximately 45°.
4.
Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Put the door with the outer side
down on a soft and level surface to
prevent scratches.
Inserting the door
To insert the door do the above steps in
the opposite sequence.
LAMP
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass cover
can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the in-
terior of the appliance. It prevents
damage to the lamp glass cover
and the cavity.
Always use the same lamp type.
Replacing the top lamp:
1.
Turn the lamp glass cover counter-
clockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant oven
lamp.
4.
Install the glass cover.
Replacing the side lamp:
1.
Remove the left shelf support to get
access to the lamp.
2.
Use a narrow, blunt object (e.g. a tea-
spoon) to remove the glass cover.
Clean the glass cover.
ENGLISH 23