User manual

TROUBLESHOOTING
Problem Possible cause and Remedy
You cannot activate the
appliance or operate it.
Activate the appliance
again and set the heat set-
ting in less than 10 sec-
onds.
You touched 2 or more
sensor fields at the same
time.
Touch only one sensor
field.
The Stop+Go function
operates.
Refer to the chapter “Oper-
ating instructions”.
There is water or fat
stains on the control pan-
el.
Clean the control panel.
An acoustic signal sounds
and the appliance deacti-
vates.
An acoustic signal sounds
when the appliance is de-
activated.
You put something on
one or more sensor fields.
Remove the object from
the sensor fields.
The appliance deactivates. You put something on the
sensor field
.
Remove the object from
the sensor field.
The residual heat indicator
does not come on.
The cooking zone is not
hot because it operated
only for a short time.
If the cooking zone operat-
ed sufficiently long to be
hot, speak to the service
centre.
The Automatic Heat Up
function does not operate.
The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting is
set.
The highest heat setting
has the same power as the
Automatic Heat Up func-
tion.
The heat setting changes
between two levels.
The Power management
is activated.
Refer to “Power manage-
ment”.
The sensor fields become
hot.
The cookware is too large
or you put it too near to
the controls.
Put large cookware on the
rear cooking zones if nec-
essary.
comes on.
The Automatic Switch Off
operates.
Deactivate the appliance
and activate it again.
comes on.
The Child Safety Device
or the Lock function oper-
ates.
Refer to the chapter “Oper-
ating instructions”.
comes on.
No cookware is on the
cooking zone.
Put cookware on the cook-
ing zone.
ENGLISH 13