User manual

1
2
2.
Pull the rear end of the shelf support
away from the side wall and remove it.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
Valid for telescopic runners:
The retaining pins on the telescopic
runners must point to the front.
CLEANING THE DOOR
To clean the door remove it.
A
A
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Removing the door
1.
Open the door as far as it goes.
2.
Fully press the clamping levers (A) on
the two door hinges.
45°
3.
Close the door until it is at an angle of
approximately 45°.
4.
Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Put the door with the outer side
down on a soft and level surface to
prevent scratches.
Installing the door
To install the door do the above steps in
the opposite sequence.
LAMP
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass cover
can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the in-
terior of the appliance. It prevents
damage to the lamp glass cover
and the cavity.
Always use the same lamp type.
Replacing the top lamp:
1.
You can find the lamp glass cover at
the cavity ceiling.
Turn the lamp glass cover clockwise to
remove it.
26
www.electrolux.com