User manual

BEFORE FIRST USE
WARNING!
Refer to "Safety information" chap-
ter.
INITIAL CLEANING AND
PREHEATING
• Remove all parts from the appliance.
• Clean the appliance before first use.
• Heat up the empty appliance at 150°C
for 30 minutes with
or function
Refer to chapter "Care and Clean-
ing".
SETTING THE TIME
You must set the time before you
operate the appliance.
When you connect the appliance to the
electrical supply the indicator for the Time
of Day function flashes.
Press the + or - button to set the correct
time.
After approximately five seconds, the flash-
ing stops and the display shows the time of
day you set.
Useful information:
• To change the time, press the Selection
button again and again until the indicator
for the Time of Day function flashes. You
must not set the Duration
or End
) function at the same time.
• In case of a power cut up to 1 hour, the
time of day is shown and the indicator
for the Time of Day function flashes.
Make sure that the time is correct and
press the Selection button to stop the
flashing.
• In case of a power cut longer than 1
hour, you must set the time again.
ENGLISH 7