User manual

Hob installation

. Cut out the worktop according to the cutout size.

The tolerances must not be exceeded. Precisely

saw at the marked line.

. With tile--coated worktop areas any slits in the

surfaceofthecookingareamust befilledupcom-

pletely.

. Clean the worktop in the cutout area

. The hob is fitted from the top into the cut--out sec-

tion, centered and firmly pressed on until the

springs will catch.

. Check the sealing in the supporting frame for per-

fect seatingandrestingwithout agap. Please do

not applyadditionalsilicone sealing material.

It will make it harder to dismantle in case of ser-

vice.

. 5 holes in the bottom of the build--in case are pro-

vided for the screws of the fitting plates.

. At first screw on the fitting plates with a screw-

driver and afterwards tighten the plates alterna-

tively and diagonally

, until the frame of the cook-

ing area is perfectly laying on the worktop.

. Over--tightening must be avoided! Electric screw-

drivers are to be exclusively used with slip clutch

(setting value 1 -- 1.1 Nm).

frame

ceramic glass plate

fixing clamp

worktop