User manual

1 Safety Instructions for the Installer

• A device must be provided in the electrical installation which allows the

appliance to be disconnected from the mains at all poles with a contact

opening width of at least 3 mm

Suitable isolation devices include line protecting cut-outs, fuses (screw

type fuses are to be removed from the holder), earth leakage trips and

contactors.

• In respect of fire protection, this appliance corresponds to type Y (EN 60

335-2-6). Only this type of appliance may be installed with a high cup-

board or wall on one side.

• Drawers may not be fitted underneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is fitted must satisfy the stability

requirements of DIN 68930.

• For protection against moisture, all cut surfaces are to be sealed with a

suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits must be

completely filled with grout.

• Ensure that the seal is correctly seated against the work surface without

any gaps. Additional silicon sealant must not be applied; this would make

removal more difficult when servicing.

• The hob must be pressed out from below when removed.