User manual

29
Setting the hob for the
new gas type
1. If necessary, activate the top by touching
the main ON/OFF Control for about
3 seconds.
2. Touch the Timer Control repeatedly
to select the auxiliary burner (front left
burner) on the burner selection display.
3. Touch the Increasing Control and
hold the finger on it until the value 99
appears on the time display. Then, touch
the Decrasing Control and hold the
finger on it until the value 80 is displayed.
4. Then, touch the Increasing Control
until 83 is displayed. At this point, the
hob is set to the “Gas Change” mode
and the current gas setting appears on
the display:
- n0 stands for gas G20 (20 mbar)
- n1 for gas G30/G31 (28-30 mbar)
IMPORTANT: setting n2 does not
allow the hob to function.