User manual

30
5. Touch the Decreasing Control to
select the required type of gas.
6. After selecting the type of gas, switch
off the hob touching the main ON/OFF
Control .
7. Touch the main ON/OFF Control
again to reactivate the hob.
The appliance is automatically set to the
normal “User Mode”.
8. Light all the burners and adjust their
flame to minimum, in order to check the
flame stability (visual check).
9. At the same time, check the flame
aspect (visual check).
If both the flame stability and the flame
aspect are satisfactory, the setting of the
hob for the new gas type is completed.
If the flame stability is not satisfactory, carry
out an additional adjustment as described
in the following paragraph.
Minimum flame adjustment
If the flame stability and the flame aspect
are not satisfactory, proceed as follows:
1. Carry out the steps described in the
paragraph “Setting the hob for the new
gas type” - points 1, 2, 3, and 4.
2. Light the burner to be adjusted following
the instructions given in the paragraph
“How to light a burner”.
The burner is automatically set to the
minimum flame level.
3. If the flame minimum level is too low, the
burner extinguishes. The hob
automatically carries out a minimum
level adjustment and then relights the
burner.