user manual Gas hob IL EHT60418
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 7 7 8 Care and cleaning What to do if… Technical data Environment concerns 8 10 11 11 Subject to change without notice SAFETY INFORMATION Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover.
electrolux 3 • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch the appliance or hot cookware. Do not let electricity bonds tangle. • If there is a crack on the surface, disconnect power supply to prevent the electric shock. Installation • You must read these instructions.
electrolux • A qualified electrician must install the clamping connections correctly. • Use a strain relief clamp on cable. • Use the correct mains connection cable and replace the damaged mains cable with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm.
electrolux 5 – it shows no throttles; – it is not subject to traction or torsion; – it does not get in touch with cutting edges or corners; – it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: – it does not show cracks, cuts, marks of burnings on the two ends and on its full length; – the material is not hardened, but shows its correct elasticity; – the fastening clamps are not rusted; – expired term is not due.
electrolux • Connect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. automatic line protecting cutout, earth leakage trips or fuse. • None of a parts of the connection cable can not get a temperature 90°C. The blue neutral cable must be connected to the terminal block label with "N".
electrolux 7 50 cm2 120 cm2 360 cm2 180 cm2 MANUFACTURER: ELECTROLUX ITALIA S.p.A. C.
electrolux 1 2 3 4 1 2 3 4 Burner cap Burner crown Ignition candle Thermocouple Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute.
electrolux 9 Warning! For safety reasons, do not clean the appliance with steam cleaners or high-pressure cleaners. Warning! Do not use abrasive cleaners, steel wool pads or acids, they can cause damage to the appliance. Scratches or dark stains on the glass have no effect on how the appliance operates. • You can remove the pan supports to easily clean the hob. • To clean the enamelled parts, cap and crown, wash it with warm soapy water and dry it carefully before you put them back.
electrolux WHAT TO DO IF… Problem Possible cause There is no spark when lighting the gas Remedy • There is no electrical supply • Make sure that the unit is connected and the electrical supply is switched on. • Control the fuse. If the fuse is released more than one time, refer to a qualified electrician. • Burner cap and crown are placed uneven • Make sure that the burner cap and crown are in correct positions.
electrolux 11 Use the original spare parts only. They are available at Service Force Centre and approved spare parts shops. TECHNICAL DATA Hob dimensions Electric supply: 230 V ~ 50 Hz Width: 580 mm Category: I3B/P Length: 510 mm Gas connection: G 1/2" Hob recess dimensions Gas supply: Width: 550 mm Length: 470 mm G30/G31 (3B/P) 30 mbar Appliance class: 3 By-pass diameters Heat input Rapid burner: 2.45 kW Semi-rapid burner: 1.
www.electrolux.
