User manual

Incorrect cookware position:
5.4 FlexiBridge Max Bridge
mode
To activate the mode press until you
see the correct mode indicator . This
mode connects all sections into one
cooking zone. To set the heat setting use
any of the two control bars on the left
side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected
sections. If you use cookware smaller
than three sections the display shows
and after 2 minutes the zone switches
off.
Incorrect cookware position:
5.5 PowerSlide function
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
The function divides the induction
cooking area into three areas with
different heat settings. The sides of the
areas in this mode illuminate. The hob
detects the position of the cookware and
adjust the heat setting corresponding
with the position. You can place the
cookware in the front, middle or rear
position. If you place the cookware in the
front you get the highest heat setting. To
decrease it, move the cookware to
middle or rear position.
Use only one pot when you
operate the function.
www.electrolux.com14