Manual

operation
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
Temp System
Temp On/Off Plus Display Area Lock Status
Minus Keypad Keypad
Keypad Keypad indicators
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Figure 8
ElectronicControlDisplay
_ TOwake the display press any keypad. A
confirm tone will sound, and the current
storage compartment temperature will be
displayed.
Sta rtin_ your appliance= = __*_
Plug the appliance power cord into a 115
volt wall outlet, Your appliance is shipped
from the factory in the "On" position and
will begin start-up of cooling as soon as _ B
power is supplied, if the appliance does "_
not start, confirm that the wall outlet has
power, and that the control is in the "On"
position, (See "Turning your appliance On
and Off"),
The control display is covered with a clear
plastic film. This film may be removed by
carefully lifting the film at a corner.
On initialpower up, the control display will
indicate a "Power Failure"alarm. This is
a normal condition as the appliance was
powered-up atthe factory for quality inspection
and then removed from power.A momentary
press ofthe "On/Off" keypad will reset this
alarm condition. (SeeAlarms section).
//
Sleep mode:
if no keypads are pressed for 60 seconds,
the display will enter sleep mode to
conserve power. The control panel will
go dark with the exception of the system
status "OK" indicator which will remain
enabled. Alarm conditions will wake the
display, (see Alarms section).
To make the following changes to the
control settings (turning the appliance ON/
OFF, adjusting the temperature, changing
the interior lights, and activating vacation
mode), the control must be awake,
The sleep mode can be disabled if you
prefer to have the display on continuously.
Press and hold the "Lock" keypad until the ,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
display goes past "hoc" and reads "nSh", iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
To enable the sleep mode, repeat the iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
instruction, again going past "hoc" until the iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
disp,ayreads"SLP" iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
TurningyourapplianceONandOFF: iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
If the appliance is "On", (and outofsleep iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
mode) thetemperaturewillbeshownin iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
thedisplayareaofthecontrol, Toturnthe iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
appliance "Off", pressand hold the "On/ iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Off" keypadforfourseconds, "OFF" will iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
nowbedisplayedonthecontrol, iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Toturntheappliance "On", pressand hold iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
the"On/Oft"keypadforfoorseconds,iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii