Manualshelf

Installation guide

ManualsBrandsElectrolux ManualsMicrowave Hood ComboOfficial Electrolux microwave/hood combo
12345678910
|NSTALLA'rioN INsrRucrIoNS
BEFORE YOU BEGIN
Readtheseinstructionscompletelyandcarefully.
• _ Save these instructions for local
inspector's use.
• _ Observe all governing codes and
coordinates.
• NOTI;' TO iNSTALLER - Be sure to leave these
instructions with the Consumer.
• NOTE TO CONSUMER - Keep these instructions for
future reference.
• SKILL LEVEL- Installation of this appliance requires
basic mechanical and electrical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
If a new electrical outlet is required, its installation should
be completed by a qualified electrician before the Over the
Range Microwave Oven is installed. See 3 ELECTRICAL
GROUNDING INSTRUCTIONS on page 2.
1 MOUNTINGSPACE
This Over the Range Microwave Oven requires a mounting
space on a wall as shown in Figure 1. It is designed to be
used with standard 12" wall cabinets.
Backsplash Atleast2"
30"or more
from cooking
surface
i
FiguPe 1
66" or more
from floor
2 WALLCONSTRUCTION
This Over the Range Microwave Oven should be mounted
against and supported by a flat vertical wall. The wall must
be flat for proper installation. If the wall is not flat, use spacers
to fill in the gaps. Wall construction should be a minimum of
2"x 4" wood studding and 3/8"or more thick dry wall or plaster/lath.
The mounting surfaces must be capable of supporting weight
of 110 pounds--the oven and contents--AND the weight of
all items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum of one 2" x 4"
wall stud.
To find the location of the studs, one of the following methods
may be used:
A. Use a stud finder, a magnetic device which locates the
nails in the stud.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with
a small nail to find the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.
NEEDHELP?
For customers in the United States and Canada
United States: 1-800-944-9044
Canada: 1-800-265-8352
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
316495060
TINSEB196WBRZ-EL82
PrintedinThailand

Summary of content (24 pages)