Service manual

WWaatteerr CCoonnnneeccttiioonn ((SStteeaamm MMooddeell OOnnllyy))
1. Turn off COLD water supply to washer,
2. Remove COLD inlet hose from COLD water
supply and inspect for rubber washer. Replace
washer if it is torn or worn out.
3. Momentarily turn on COLD supply and run
some water into a bucket or container to clear
any contaminants in the line.
4. Remove hose kit from dryer drum and inspect
hose couplings for proper placement of rubber
washers. (See Figure 2-14)
5. If your installation has room for the COLD
water supply to accept the “Y” connector
directly, thread the “Y” connector to the COLD
water supply and snug it by hand; then tighten
it another 2/3 turn with pliers.
6. If there is not room to install the “Y” connector
directly, thread the short extension hose on to
the COLD water supply and snug it by hand;
then tighten it another 2/3 turn with pliers.
7. Thread the “Y” connector to the short
extension hose and snug it by hand; then
tighten it another 2/3 turn with pliers.
8. Connect the COLD inlet hose for the washer
to the “Y” connector and snug it by hand; then
tighten it another 2/3 turn with pliers.
9. Connect the straight end of the long hose from
the kit to the other outlet on the “Y” connector
and snug it by hand. Connect the hose’s 90°
coupling to the brass water inlet on the back
of the dryer and snug it by hand. Tighten each
connection of the dryer inlet hose another 2/3
turn with pliers.
10. Turn on the water and check for leaks at all
connections.
IInnssttaallllaattiioonn IInnffoorrmmaattiioonn
2-13
NOTE
IIff yyoouu wweerree aabbllee ttoo iinnssttaallll tthhee ““YY”” ccoonnnneeccttoorr
ddiirreeccttllyy ttoo tthhee CCOOLLDD wwaatteerr ssuuppppllyy,, pplleeaassee sskkiipp
ttoo sstteep
p 88..
FFiigguurree 22--1144..