Service manual

IInnssttaallllaattiioonn IInnffoorrmmaattiioonn
2-17
RReemmoovviinngg HHiinnggee ffrroomm FFrroonntt PPaanneell
1. With the hinge in open position, remove 2
short, course-thread, panhead screws on
hinge plate. (See Figure 2-21)
2. Remove 3 short, fine-thread, counter-sunk
screws in hinge side. (See Figure 2-22)
3. Slide the hinge toward the center of the front
panel, and then pivot the hinge inward while
slowly pulling it away from the front panel to
expose the attached harness.
4. Lift up on the tab and the release harness
from the retainer, allowing the harness to lay
outside the front panel. (See Figure 2-23)
RReemmoovviinngg DDoooorr LLoocckk ffrroomm FFrroonntt PPaanneell
1. Remove 2 short, course-thread, panhead
screws from the door lock.
(See Figure 2-24)
2. Slide the lock toward the outer edge of the
front panel. Pivot the lock slightly outward
while slowly pulling it through opening to
expose the attached harness.
(See Figure 2-25)
3. Release the harness from the terminal with
the small lever on back of the lock. Separate
the harness from the lock, allowing the
harness to lay outside the front panel.
(See Figure 2-26)
FFiigguurree 22--2211..
FFiigguurree 22--2222..
FFiigguurree 22--2233..
FFiigguurree 22--2244..
FFiigguurree 22--2255..
FFiigguurree 22--2266..