Service manual

IInnssttaallllaattiioonn IInnffoorrmmaattiioonn

2-22

RReevveerrssiinngg TTrriimm RRiinngg

1. Trim ring orientation is marked on the back.

2. Remove the trim ring cover plate. To remove

the cover plate from the right, pivot point is

up. To remove the cover plate from the left,

pivot point is down. (See Figure 2-45)

RReeiinnssttaalllliinngg TTrriimm RRiinngg

1. Close the door.

2. Orient the trim so 12 position is approximately

¾” to the left of top center. The opening in the

trim ring should be on the hinge side.

3. Insert the trim ring in the slots and rotate it

clockwise approximately ¾”. (See Figure 2-46)

RReeiinnssttaalllliinngg TTrriimm PPlluugg

1. Open the door to a 90 degree angle.

2. Install the trim plug with 1 long, course thread,

panhead screw. (See Figure 2-47)

3. Plug in washer and continue operation.

FFiigguurree 22--4455..

FFiigguurree 22--4466..

FFiigguurree 22--4477..